DC315: Certified Approved Thermal Barrier over (SPF) Polyurethane Foam. DC315 passed two “UL1715” Room Fire Tests at the highest spread rate on the market. Warnock Hersey Listed. DC315 is a Green Product, VOC is Less then 50 g/l. What is truly amazing about DC315, it applies as easy as regular latex paint and being a water base it cleans up in a snap.  Learn More

Using DC315 will satisfy IBC code compliance for ”15 Minute Thermal Barriers” and “Ignition Barriers” on your next foam job means:

• Large single coat spread rate
• UL-1715 Thermal Barrier
• (88.88 sq. ft./gal @ 18 mils wet and 12 mils dry) coverage rate of 1.136 gallons (4.3 L) per 100 square feet (9.3 m²)
• NFPA 286  (AC377) Attic Crawl Space Ignition Barrier
• (130 sq. ft./gal @ 12 mils wet 8 mils dry) coverage rate of .77 gallons (2.9 L) per 100 square feet (9.3 m²)
• Reduced labor cost, reduced material cost and higher profits
• Fast turnaround time
• No formaldehyde
• Easily applied with a sprayer, brush or roller
• No complicated mixing- just stir the paint before application
• No waste
• Fast and easy clean up of our water base latex paint, tools & equipment
• Will not gum up or block spray equipment
• Passed strict EPA – VOC and AMQD tests
• Non Toxic, Low Vapors, Low VOC less the 50 making DC315 a Green Product.
• Two year shelf life
• Certified Code Compliant Coating 

RECOMMENDED USES: This product is designed for use on interior polyurethane foam surfaces

USED BY: Schools, Colleges, Nursing Homes, Child Care Centers, Hospitals, Penal Institutions, Apartments, Hotels, Factories, Warehouses, Retail Stores, Restaurants, Utilities, Railroad and other Transportation Companies, Oil and Chemical Installations, Military Installations, and other facilities where fire retardant coatings are required.

PRECAUTIONS:  Adequate ventilation must be provided during and after application until the coating has dried. Avoid breathing vapors or spray mist. Close container after use.

Read MSDS before opening containers.

SURFACE PREPARATION: Can be applied directly to fully cured polyurethane foam surfaces. All surface preparation should be carried out in accordance with good painting practices. Remove all loose, peeling or powdery existing paint from the surface. All dirt, grease, oil, wax, and other foreign matter MUST be removed with a detergent, rinse surface thoroughly with clear water, and allow drying.

Application Equipment: 

Tip:                                                021 - .029, or equivalent.
Filter:                                             60 mesh
Hose:                                            Use minimum size of 3/8” airless spray line for the first 50’ from pump.

Fluid Pressure:                           2000 PSI or higher
Strainer:                                       60 Mesh
Fluid Hose:                                  3/8 diameter with a ¼”  whip
Tip:                                                521 - 529

Air Supply:                                   12 CFM, 50 psi at nozzle,
Fluid:                                             5-20 psi
Gun:                                              Graco 217-800 to 217-816
Type:                                             External Mix
Reduction:                                   Up to 7%